Table of Contents
Advertisement
SECTION II.
OPERATOR'S CONTROL PANEL
character referenced by the setting of the ADDRESS indi-
cators and to increment or decrement the controlling
register to the next sequential location.
NOTE: If the displaying of the characters is to begin
with the current setting of the program, the
characters displayed in the CONTENTS indi-
cators begin with the character designated by
the current setting of the ADDRESS indicators.
Otherwise, the display begins with the charac-
ter referenced in the address selected by the
operator in step "a" above.
f.
Press repeatedly the CONTROL DISPLAY+l or the CONTROL
DISPLA Y -1 button until the desired successive memory lo-
cations have been displayed in the CONTENTS indicators.
3.
To write characters into successive main memory locations:
a.
If
it
is desired to enter information into successive main
memory locations beginning with the current setting of the
program, proceed to step "d" below.
If it is de sired to enter
information into some location(s) beginning with other than the
current setting of the program, manually enter (by pressing
the appropriate ADDRESS buttons) the desired starting address
into the memory address register.
b.
Press the CONTROL buttons to designate the desired controlling
register (octal 16 or 07).
c.
Press the CONTROL ENTER button to set the control memory
register selected in step "b" above to the starting address
selected in step "a" above.
d.
Press the CONTROL DISPLAY+l or the CONTROL DISPLAY-l
button, depending on the desired direction of character entry
into main memory.
NOTE: No incrementation or decrementation takes places
upon the first depression of either button.
e.
Press the CONTROL DISPLA Y+l or the CONTROL DISPLAY-l
button again to display in the CONTENTS indicators the charac-
ter referenced by the setting of the ADDRESS indicators and to
increment or decrement the controlling register to the next
sequential location.
NOTE: If the entering of the characters is to begin with the
current setting of the program, the character dis-
played in the CONTENTS indicators is the one desig-
nated by the current setting of the ADDRESS indi-
cators.
Otherwise, the character displayed is the
one referenced in the address selected by the opera-
tor in step "a
II
above.
f.
If a different character from that displayed in step "e" above is to
be written into the desired memory location, press the CONTENTS
CLEAR button.
g.
Press the CONTENTS buttons to create the octal equivalent of the
de sired character.
h.
Press the CONTENTS ENTER button to write the desired charac-
ter into main memory.
2-14
Advertisement
Table of Contents
