Table of Contents
Advertisement
4.5
Installation procedure
①
②
③
④
⑤
⑥
⑦
1. Remove the existing flat roll idler (or flat slider pan) from the area selected to locate the belt
scale assembly.
2. Drill four 8 mm (5/16") diameter mounting holes. This will allow clearance for 6 mm bolts.
Note
Slotting the holes vertically will permit greater adjustment capability.
3. Position the scale with the weighdeck towards the head end (discharge) of the conveyor and
the load cells toward the tail end (infeed).
– Raise the conveyor belting to provide room for the installation of the scale.
4. Insert the scale (modules) onto the conveyor.
– Insert four M6x1 bolts through the conveyor frame and through the holes in the sides of
– Secure the bolts, finger tight only.
Milltronics WD600
Operating Instructions, 09/2016, A5E38964753_AB
Belt
Weigh span
Weigh deck
Minimum 4.75" (121 mm), both sides must be equal
Test weight hanger bracket
Load cell
Existing slider belt support
the load cell mount pads.
Installing/Mounting
4.5 Installation procedure
17
Advertisement
Table of Contents
