Tone Remote - Motorola R-2200 Operator's Manual

3.4.3.4 B Same form as A
3.4.3.5 AlB T&V This sequence is for standard Motorola
2-tone paging. All timing is preprogrammed via soft-
ware. The prompt sequence is the "A FREQ" followed
immediately by the "B FREQ". First enter the A fre-
quency in the blinking cursor position. Once the frequen-
cy is loaded, press
I
En"'
I,
the unit will immediately pro-
vide the "B FREQ" prompt. Enter the B frequency and
press
I
En'"
I
to load.
For example, program a paging sequence for Motorola
two-tone paging formats using frequency 147.2 Hz and
227.5 Hz as:
Press Press
Numeric Program
Key Key Display Comment
Select "AlB T & V"
§
225.6 Hz Old "A" Frequency
. .
Is Displayed
1472 147.2 Hz
I
Ent.,l
254.4 Hz Old "B" Frequency
Is Displayed
2275
227.5Hz
I
Ent"
I
NOTE: Shaded area is flashing digit. (point of data entry)
3.4.3.6 AlB V AR This sequence is for other 2-tone paging
codes for which the software provides six sequential
prompts before the programming is complete.
1. "A FREQ" as above.
2. "B FREQ" as above.
3. The "A OUR" (duration) prompt allows the timing
of the first paging tone to be set in the range of 0.00
to 9. 99 seconds. Enter the time and press
I
En• ..
I
to
load.
4. The "B OUR" time is set in the same manner.
5. The "A DLY" (delay) prompt allows the interdigit
time to be set in the range of 0.00 to 9.99 seconds.
Enter the time and press
I
En• ..
I
to load.
6. The "B DLY" time is set in the same manner and is
the delay time between the end of TONE Band the
repeat of TONE A.
3-6
Press Press
Numeric Program
Key Key Display Comment
Select "AlB" Var
Modulation Code
§
I
284.8 Hz Old "A" Frequency
Is Displayed
1366
136.6 Hz
I
Ent"
I
174.5 Hz Old "B" Frequency
Is Displayed
1950
195.0 Hz
I
En"'
I
0.50 Sec Old "A" Tone Duration
I
Ent .. l
Leave At 0.50 Seconds
0.50 Sec Old "B" Tone Duration
025 0.25 Sec
I
Ento'
I
0.30 Sec Old Interdigit Time
000
I
Ento'
I
0.00 Sec
5.00 Sec Old Repeat Cycle Time
I
Ent"
I
Leave At Same
Recycle Rate
NOTE: Shaded area indicates flashing digit. (point of data
entry)
3.4.3. 7 TONE REMOTE This sequence is for console to
base control using standard Motorola tone remote con-
trol. All timing and level changes are preprogrammed via
software. The prompt sequence is started by pressing
I
b:~:
1.
The first prompt displayed is
"A
FREQ" for Hi and
Low Guard (normally 2175Hz) tone. Program the fre-
quency using the numbered membrane keys, depress the
8
key to load. The "B FREQ" prompt follows and the
same key strokes to enter a function tone are required.
For example, program a Motorola tone remote control
sequence of 2175 Hz guard tone and 1950 function tone
as:
\........,../
~