Advertisement
To Operate
LAM-P SWITCH
FAN SWITCH
Lamp Switch
CENTER position OFF, LEFT position NIGHT LIGHT,
RIGHT position BRIGHT LIGHT.
Fan Switch
CENTER position OFF, LEFT position LOW SPEED,
RIGHT position HIGH SPEED.
To Maintain
Replaceable Filter
The efficiency of your hood depends upon a clean filter.
The frequency of filter replacement depends on the type of
cooking you do; however, with average, normal usage,
replacement should be every 6 to 12 months.
NEVER OPERATE YOUR HOOD WITHOUT THE
FILTER IN PLACE.
When to replace the filter: The filter has distinct color
stripes of indicating material on the visible surface. It is
TIME TO CHANGE when the stripes have either
blended together or faded completely.
To remove: Push on the retaining clip to release the
right edge of the filter. The filter will then slip out of the
retaining slot on the left.
To replace: Slip the left edge into the retaining slot.
Push the right side of the filter up and lock in place with
the retaining clip.
Replace with genuine GE part: filter part number
WB02X9761.
To order, call: Your local GE dealer, GE Service & Parts
Center (see the telephone White Pages) or GE Answer
Center 1-800-626-2000.
Hood
Clean grease laden surfaces of the hood frequently. Use
warm detergent solution. About 1 tablespoon of
ammonia may be added to the water. TAKE CARE TO
NOT COME IN CONTACT WITH FILTERS AND
OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.
CAUTION: Be certain when cleaning hood
surfaces you do not touch lamp bulb with moist
hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.
Motor and Fan
To Clean Motor and Fan
1. DISCONNECT THE HOOD POWER SUPPLY AT
THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF THE
CIRCUIT BREAKER.
2. Remove filter.
3. Wipe fan blade and motor with cloth, dampened only
in ammonia and warm water solution.
4. Replace filter.
5. Reconnect the hood power supply.
Lamp Replacement
Remove the filter as instructed at left. Then slide the
lamp cover toward the rear to expose the lamp.
Remove and replace with ordinary screw-base lamp bulb
NOT MORE THAN 60 WATTS.
Reinstall the lamp cover and filter.
CAUTION: Let lamp cool completely before
removing. A warm or hot bulb may break if touched
with a moist cloth or hand.
WARNING: THE ELECTRICAL WIRING AND
FAN MOTOR IN THIS RANGE HOOD ARE NOT
INTENDED FOR USE WITH, OR PROVIDED
WITH A SOLID STATE SPEED CONTROL. ANY
SUCH ALTERATION FROM ORIGINAL
FACTORY WIRING CONCEPT COULD RESULT
IN DAMAGE TO THE UNIT AND/OR CREATE
AN ELECTRICAL SAFETY HAZARD.
2
—.
Advertisement
