Table of Contents
Advertisement
Bosch Rexroth AG
Assembly, Disassembly and Electrical Installation
10.3 Mounting
Mounting the UPS on the mounting rail
CAUTION
Fasten the UPS on a stable mounting rail. A mounting rail which is not stable
enough can deform during transport, and therefore the UPS can get loose. Only
use mounting rails made of steel TH 35-7.5 and TH 35-15 according to
EN 60715.
Determine the distance of the mounting holes according to EN 60715 appen-
dix B.
Hang the UPS onto the mounting rail from above. Exert slight pressure to en-
gage the UPS in the lower section of the housing.
Attaching the end clamps
Mount end clamps on the mounting rail on both sides of the UPS to avoid lateral
moving of the UPS if vibrations occur. The end clamps are available as accesso-
ries, see
chapter 5.4 "End Clamp" on page
20/53
Possible personal injury and material damage
due to a UPS that loosens from the mounting
rail caused by insufficient fastening.
8.
VAU 01.1
DOK-SUPPL*-VAU*01.1X**-IT02-EN-P
Hide quick links:
Advertisement
Table of Contents
