Advertisement
1. Professional Grade, High Output AGM Battery
2. Charging Status LEDs
3. On/Off Switch
4. Internal Battery Status Switch
5. Internal Battery Status LEDs
6. 12 Volt DC Power Outlet
7. Heavy Duty, Battery Clips
8. Durable Polypropylene Case
9. Clamp Holder
4.3.2. TO CHECK THE INTERNAL BATTERY'S CHARGE STATUS, MAKE SURE THE WALL CHARGER IS NOT PLUGGED INTO THE
ROADSTART, THEN PRESS THE BATTERY STATUS BUTTON ON THE FRONT OF THE ROADSTART.
The LED lights will indicate the charge level as follows:
• A red LED indicates a 50% or less charge and you should immediately recharge the RoadStart.
• A yellow LED indicates a 50 to 75% charge. The RoadStart may be used but should be recharged as soon as possible.
• A green LED indicates the internal battery is fully charged.
• The CHARGING (red) LED indicates the RoadStart is charging (connected to an AC power source.) At full charge, the CHARGED
(green) LED will light.
4.3.3. IMPORTANT: Only use the charger that was included with the RoadStart to charge the internal battery of the RoadStart. Using any other
charger or using the included charger for any other purpose could result in personal injury or property damage.
4.3.4. To charge, plug the included wall charger into the charger plug on the back of the RoadStart.
4.3.5. Confirm the AC outlet voltage matches the input voltage of the wall charger.
4.3.6. Plug the wall charger into an electrical wall outlet. Make sure to place the charger on a dry, nonflammable surface like metal or
concrete.
4.3.7. While the RoadStart is charging, the CHARGING (red) LED will be lit. When the internal battery is fully charged, the CHARGED (green)
LED will light. Complete charging may take up to 30 hours. The RoadStart is then ready to use.
4.3.8. The charger will automatically go into maintain mode and maintain the battery at full charge without damaging it.
IMPORTANT: DO NOT use the RoadStart while charging the internal battery.
4.4.
Operating Instructions: Jump Starting a Vehicle Engine
WARNING! A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION.
TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY:
1. Turn the vehicle's ignition OFF before making cable connections.
2. Connect the RoadStart to the vehicle's battery as described in Section 4.
3. Turn the RoadStart ON/OFF switch to the ON position.
4. Crank the engine. If the engine does not start within 3-8 seconds, stop cranking and wait at least 1 minute before attempting to start
the vehicle again. (This permits the RoadStart battery to cool down.)
5. After the engine starts, turn the RoadStart ON/OFF switch to the OFF position.
6. Disconnect the RoadStart from the vehicle, as described in Sec. 4.2.
7. Return the battery clips to the clamp holders. Recharge the RoadStart as soon as possible after use.
4.4.1.
When using the other features of the RoadStart, always observe the following steps:
1. Ensure the battery clips are securely clipped on the clamp holders.
2. Charge the RoadStart as soon as possible after using the feature.
4.5.
Operating Instructions: Powering a DC device
The RoadStart is a power source for all 12V DC accessories that are equipped with a 12V accessory plug. Use it for power cuts and
fishing or camping trips.
Make sure the device to be powered is OFF before inserting the 12V DC accessory plug into the 12V DC accessory outlet.
© Jack Sealey Limited
Original Language Version
PBI1812S
Issue: 1 - 30/04/14
Advertisement
