Troubleshooting Guide - Whirlpool WD 142 Instructions For Use Manual

I
F THE DRAWER DOES NOT WORK
made the checks in the table below.
T
HIS IS TO AVOID
When calling for Service, please give the serial number and type
number of the drawer (see Service label on the underside of the
drawer). Consult your warranty booklet for further advice.
P
ROBLEM
D does not work
RAWER
D does not slide
RAWER
properly
T excessive moisture on
HERE IS
the drawer
F out
OOD DRIES
T not hot enough
OO HOT OR
P is off but drawer
ILOT LAMP
works
T
HE DRAWER REPEATEDLY STOPS
unepectedly but works again
after circuit reset
12
TROUBLE SHOOTING GUIDE
, do not make a service call until you have
unnecessary calls for which you will be charged.
P
OSSIBLE CAUSE
Is the drawer connected to a
power source?
Has the household fuse or
circuit breaker been tripped?
Is the ball bearings out of
alignment?
Is the drawer properly
mounted on the slides?
Is the drawer overloaded?
Is the drawer load uneven?
Has much dirt collected be-
neath the drawer?
The use of aluminum foil to
cover food may cause mois-
ture to collect and drip into
the drawer.
Uncovered foods?
Moisture escaping.
Has the dishes been warmed
long enough?
Is the door closed properly?
The lamp may be broken?
the thermostat may be bro-
ken.
S
OLUTION
Refer to installation instructions to
ensure proper installation.
Replace the fuse or reset the cir-
cuit breaker. If the problem con-
tinues, call an electrician.
Fully extend the drawer and push
it all the way in a couple of times.
Remove and remount the drawer
on the slides.
Reduce weight. Weight inside
drawer should not exceed 25 Kg.
Redistribute drawer contents
evenly.
Remove the drawer and clean
carefully.
Cover food with plastic foil.
Cover food with lid.
Cover food with lid or plastic
wrap.
Set the temperature control knob
to the proper setting.
Check door sealing and close
door.
Let the drawer cool off and re-
peat. If the problem persists, call
service!
Let the drawer cool off and re-
peat. If the problem persists, call
service!