Craftsman 486.24489 Operator's Manual page 5

StEP 4: (SEE FIGurE 4)
• Lay the tongue (open side facing up) onto the wheel
support. Assemble the axle through the wheel
support and the tongue.
FIGurE 4
StEP 5: (SEE FIGurE 5)
• Assemble an axle clip (N), a washer (E), a wheel with
the valve stem facing out, and another washer (E)
onto the axle. Secure them in place with a 1/8" x 1-1/4"
cotter pin (K). Repeat for other wheel.
(E)
(K)
FIGurE 5
786.24489
(E) (N)
StEP 6: (SEE FIGurE 6)
• Assemble the latch stand plate and the latch stand
bracket at the front of the tray using four hex bolts (A)
and hex nuts (F). The aligning tab on the bottom of
the latch stand bracket must be towards the rear of
the cart. tighten.
FIGurE 6
StEP 7: (SEE FIGurE 7)
• Place the tray onto the wheel support and position
it so that the latch stand bracket locks into the latch
lock lever. Fasten the tray to the wheel support using
eight hex bolts (B) and hex nuts (G). tighten.
FIGurE 6
5
(A)
(F)
(B)
(G)