Light-Emitting Diode (Led) Indications - GE GFK-2892F User Manual

Pacsystems rx3i genius communications gateway
Table of Contents

Advertisement

Chapter 2. Installation

Light-Emitting Diode (LED) Indications

The four LEDs in the module header provide a visual indication of the GCG001 module status.
POWER — indicates the presence of power to the module.
Green, ON steady
OFF
OK — indicates GCG001 readiness to perform normal module operations.
Green, ON steady
Green/Amber,
blinking
Amber, ON steady
OFF
FAULT — indicates the detection of faults by the module.
OFF
Red, blinking 2Hz
Red, ON
CONNECT — indicates status of the connection to a PROFINET controller.
OFF
Red, blinking
Red, ON
The two LEDs associated with each Ethernet port (used here as PROFINET ports) are labelled ACT and LINK.
These LEDs provide information about activity on that particular port.
PORT 1, PORT 2 LINK — indicates connection status on Ethernet ports.
Green, ON steady
OFF
PORT 1, PORT 2 ACT — indicates activity on PROFINET ports.
Amber, blinking
OFF
The LED located directly above the Genius connector provides information about the Genius bus.
COM — indicates the status of Genius Bus communications.
Green, ON steady
Green, blinking
OFF
22
Power supply is good.
Power supply is off or not good.
Module able to perform normal operations.
Module loading main operating system
Module loading boot-loader operating system
Module has an unrecoverable fault or power is not applied.
No faults present.
DCP Device Identification Signal received on PROFINET.
A fault or other PROFINET diagnostic data exists on the Gateway
One or more connections with GE PROFINET Controllers have been
established to this device.
Device trying to connect to a controller.
Continuous if device has not been assigned a valid station name.
No PROFINET Controller connection
Ethernet connection established
No Ethernet connection
Communications occurring on port
No communication
The Genius Bus is configured and operating properly.
A Genius Bus error has been detected.
The Genius Bus has failed or no Genius Bus configuration has been
received.
PACSystems RX3i Genius Communications Gateway
GFK-2892F

Advertisement

Table of Contents
loading

Table of Contents