1-6. Installing the RM-B750
This section describes the installation procedure when the
front panel of the remote control unit RM-B750 is used by
being installed to HDCU1500.
Removing the Front Panel from the RM-B750
1. Loosen the screw with stopper of the RM-B750 and
open the cover in the direction of the arrow.
Cover
2. Loosen the four screws with stopper and open the front
panel and the rear panel in the direction of the respec-
tive arrows.
Rear panel
Screws with
stopper
Screws with stopper
. IM/HDCU1000 Series
Screw with stopper
Front panel
3. Disconnect the flexible card wires from the connectors
CN2, CN14 on the VA-211 board.
n
Be careful not to bend the flexible card wires. This
shortens the wire life.
4. Remove the screw and remove the front panel in the
direction of the arrow.
MPU-124 board
(CN104)
Flexible card wire
Front panel
B3 x 5
Flexible card wire
VA-211 board
CN2
CN14
1-11 (E)