Table of Contents
Advertisement
3. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
Rack
B4 x 10
3U
1U
Adaptor
MKS-8010A : 1U
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step2).
5. Align the groove of the rack tool at the side of the equip-
ment with the rail, and slide the equipment to the rear.
n
The rack tools are hooked on the rails as shown below.
Rack tool
Rail
6. Remove the front panel. (Refer to Section 2-1.)
1-16
Adaptor
31.75
Rack
B4 x 10
31.75
Unit : mm
Rack tool
Rail
7. Fix the rack angle in the rack using the specified
screws.
B 5 x 12
8. Attach the front panel to the equipment.
B 5 x 12
CCP-8000 IM
Hide quick links:
Advertisement
Table of Contents
