Table of Contents
Advertisement
1. Cutting-unit kickstand
3
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, best dispersion is attained when the
rear shield is closed (front discharge). When conditions are
heavy or wet, you can open the rear shield.
To open the rear shield
(Figure
securing the shield to the left side plate, rotate the shield to
the open position, and tighten the cap screw.
1. Rear shield
Figure 3
4), loosen the cap screw
Figure 4
2. Cap screw
4
Installing the Loose Parts
Parts needed for this procedure:
1
Straight grease fitting
1
O-ring
2
Screws
Procedure
Install the grease fitting on the reel-motor side of the cutting
unit. Use
Figure 5
to determine the position of the reel
motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. Remove and discard the set screw on the reel-motor
side plate
(Figure
1. Bolt (2)
2. Set screw
2. Install the straight grease fitting
3. If there are no bolts on the reel-motor side plate, install
them
(Figure
6).
4. Install the O-ring on the reel motor
5
Figure 5
5. Cutting unit 5
6. Reel motor
7. Weight
6).
Figure 6
3. Grease fitting
4. Grease vent
(Figure
6).
(Figure
7).
Advertisement
Table of Contents
