Table of Contents
Advertisement
KB-0333KS
KB-0333KK
KB-0333KW
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
Before servicing or cleaning unit, switch power OFF at service panel and lock the service disconnect to
prevent power from being switched on accidentally. When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the service panel.
LIGHT PANEL and AIR CHUTE REMOVAL/INSTALLATION
1. Switch OFF power at service panel, to prevent accidental
electrical shock, or damage to components.
2. Remove FILTERS and set aside.
3. For models with an inner BOTTOM COVER, remove two
#8 screws (A) attaching BOTTOM COVER (B) to HOOD,
tip BOTTOM COVER down and remove.
4. Remove the two #6 (C) and three #8 (D) pan head
screws attaching the LIGHT PANEL (E) to the HOOD
and lower the LIGHT PANEL to expose the LIGHT
CONNECTOR (F).
5. Disconnect the LIGHT CONNECTOR (F) and set the
LIGHT PANEL aside.
6. Remove the four #8 pan head screws (G) attaching the
AIR CHUTE (H) to the HOOD. Pull forward slightly on the
AIR CHUTE and slide to the right and remove if
neccessary.
7. Place the AIR CHUTE (H) into the HOOD and secure in
place with four #8 pan head screws (G).
8. Place the LIGHT PANEL (C) into the HOOD frame. The
front lip of the LIGHT PANEL must be slid behind the
HOOD frame lip. The remaining edges of the LIGHT
PANEL lay over top of the HOOD edges.
9. Secure the LIGHT PANEL to the HOOD using two #6 (C)
and three #8 (D) pan head screws. Reconnect the
LIGHT CONNECTOR plug (F).
10.For models with an inner BOTTOM COVER, set the
BOTTOM COVER (B) in the back edge of the HOOD and
tip up into place and secure with two #8 pan head screws
(A).
11.Install the FILTERS.
12.Switch ON power at the service panel and test the
RANGE HOOD functions.
INSTALLATION
WARNING :
4
Advertisement
Table of Contents
