Replacement Parts; Service And Repairs; Troubleshooting - Black & Decker BDEG900 Instruction Manual

Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
This Class B digital apparatus complies with Canadian ICES-003. This device complies
with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTe:
This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
LUBRICATION
Black and Decker tools are properly lubricated at the factory and are ready for use.
Tools should be lubricated regularly every year depending on usage. (Tools used on
heavy duty jobs and tools exposed to heat may require more frequent lubrication.) This
lubrication should be attempted only by trained power tool repair person such as those
at Black and Decker service centers or in other qualified service personnel.

RePLACeMeNT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our service
website at www.blackanddecker.com. You can also order parts from your nearest
Black and Decker Factory Service Center or Black and Decker Authorized Warranty
Service Center. Or, you can call our Customer Care Center at 1-800-544-6986.

SeRvICe AND RePAIRS

All quality tools will eventually require servicing and/or replacement of parts. For
information about Black and Decker, its factory service centers or authorized warranty
service centers, visit our website at www.blackanddecker.com or call our Customer
Care Center at 1-800-544-6986. All repairs made by our service centers are fully
guaranteed against defective material and workmanship. We cannot guarantee repairs
made or attempted by others.

TROUBLeShOOTINg

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Black and Decker
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a
Black and Decker service center
or authorized servicer.)
• Have cord or switch replaced
at a Black and Decker Service
Center or Authorized Servicer
12 12