Attaching The Work Bowl Cover; Installing The Adjustable Slicing Disc; Installing The Reversible Shredding Disc - KitchenAid 5KZFP11 Manual

ASSEMBLING THE FOOD PROCESSOR ACCESSORY KIT

Installing the adjustable slicing disc

Adjust the slicing thickness by holding
1
the drive adapter in one hand and
turning the adjustment collar with the
other until the desired thickness is set.
Install the work bowl cover, being sure
3
it locks into place.

Installing the reversible shredding disc

Hold the reversible shredding disc
1
by the 2 finger grips with the desired
shredding side facing UP . Insert the disc
adapter into the hole in the bottom of
the disc.
TIP: You may need to turn the disc/adapter until it drops down into place.
W10832406A_Australia_v2.indd 11
2
Finger grip
2
Hold the slicing disk by the finger grips
and lower it onto the drive shaft. You
may need to turn the disc until it drops
down into place onto the shaft.
With the work bowl installed, slide the
disc adapter onto the drive shaft. Then
install the work bowl cover, being sure it
locks into place.
Disc
adapter
11
5/3/16 11:18 AM