Wearing; How To Use; Charging; Low Battery - LG Bluetooth HBS-250 User Manual

Description of parts

Front
MUSIC JOG dial
Back
EQ/HOLD button

Wearing

Charging Port
- Widen the ear loop a little bit, in order to easily place the headset
over the ear.
- Adjust the ear loop accordingly, to ensure the most comfortable fit.
4
LED Status Indicator
PWR/CALL button
Charging port
Volume Controls
MIC

Charging

- Remove the cover on the charging port and connect the charger.
- While charging, the LED will remain on.
- The Headset will not function while charging.
- It takes 2 hours to fully charge the Headset.
- When charging is complete, the LED will turn off.

Low battery

- You will hear a periodic beep, when the battery is low.
- When the battery is not charged, the Headset will turn off.
Button Hold
- Button Hold mode prevents any button from being pressed
unintentionally.
- Press and hold the EQ/HOLD button for 3 seconds to place the
headset in hold mode.
- Press and hold the EQ/HOLD button for 3 seconds again to turn off
hold mode.
- Button Hold mode is accessible when the HBS-250 is powered ON or OFF.
- If you press any button while the Headset is in Hold mode, the HBS-250
will beep and the LED will blink, to alert you that the device is in hold
mode.
- You are unable to turn on the headset, if the HBS-250 is in hold mode.
You will need to turn off hold mode, in order to power on the device.

Battery status

By briefly pressing the Volume-Up button and Volume-Down button
simultaneously, you can check the battery status of the HBS-250, by
counting the number of LED flashes, per the below chart.
4 flashes
Number of Blue flashes
Music streaming time More than 7 h More than 4 h More than 1 h Up to 1 h

Power on

- Press and hold the PWR/CALL button for at least 2 seconds.
•
The HBS-250 will turn on and a tone will play.
•
Make sure Button Hold Mode is turned off.

How to use

3 flashes 2 flashes 1 flash
5