Craftsman 37634 Owner's Manual page 12

MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Refer to Figure 9.
Hose is attached to open end of dual inlet. To attach hose:
1. Slide hose clamp onto free end of hose. Loosen clamp
screw if required to slide hose clamp onto hose.
2. Position the hose clamp wires on the hose grooves.
3. Slide hose with clamp onto dual inlet.
4. Tighten hose clamp screw to secure hose to dual inlet.
ATTACH HANGER
V!l, viv/,_l ;1_, I I_[.€']l
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Refer to Figure 9.
Hanger is fastened on the top side of housing assembly.
To attach hanger:
1. Place narrow end of lower hanger into hanger bracket
and secure.
2. Place narrow end of upper hanger into lower hanger
and secure.
ATTACH FILTER (TOP) BAG
V!l,v_v/_,l ;i _I I_[€-]l
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Refer to Figure 9.
The filter bag is hooked onto the hanger and attached to
the housing. To attach filter bag:
1. Hang the filter bag by the loop on the hanger hook.
2. Slide the bag clamp into the loop on the bottom of the
bag. Keep sliding the bag clamp until it comes out of the
other side of the loop.
3. Gently lift the clamp handle to release.
4. Slide bag with clamp onto the opening on the housing
top.
5. Secure bag to housing by positioning the spring con-
nector into one of the slots on the latch and lock the
clamp handle.
6. Make sure top bag is secure.
ATTACH COLLECTOR (BOTTOM) BAG
V!VAv/_'I;I#I I_, [ _e]l
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
Refer to Figure 9.
1. Slide bag with clamp on to the opening on the housing
bottom.
2. Position the spring connector into one of the slots on
the latch and lock the clamp handle.
3. Make sure collector bag is secure.
Filter Bag
BagClamp
Blower Housing
Assembly
Cla_,_,
Collector
Bag
Figure 9 - Mounting Hose and Bags
C_/_mp Hose
12