7. Remove the wheel outside and the wheel tire.
8. Remove the lock washer from the axle.
9. Remove the washer, the ball bearing, the o-ring and
the wheel inside.
36 - Repair instructions
10. Remove the ball bearing, the sealing and the shield.
Note: Add grease between the sealing and the
bearing and to the ball bearing.
11. Install in opposite sequence.
Note: Replace the lock washer. An used lock washer
will not give a satisfactory lock after it is removed
from the axle.
6.21.2 To replace the rear wheels
1. Remove the hub cap.
2. Remove the nut (24 socket wrench) and the washer.
1191 - 001 -