On Illumination; On Heat Dissipation; On Screen; On Lcd Projector - Sony VPL-PHZ10 Quick Reference Manual

• On cleaning the cabinet:
Clean the cabinet gently with a soft
cloth. Stubborn stains may be
removed with a soft cloth lightly
dampened with mild detergent
solution and wrung, followed by
wiping with a soft dry cloth. Never
use solvent such as alcohol, benzene
or thinner, or acid, alkaline or
abrasive detergent, or a chemical
cleaning cloth.

On Illumination

To obtain the best picture, the front of
the screen should not be exposed to
direct lighting or sunlight.

On Heat Dissipation

The temperature of the projector
cabinet may increase during or
immediately after use; however, this is
not a malfunction.

On Screen

When using a screen with an uneven
surface, stripes pattern may rarely
appear on the screen depending on
the distance between the screen and
the unit or the zooming
magnifications. This is not a
malfunction of the unit.
On Fan
Since the projector is equipped with a
fan inside to prevent internal
temperature from rising, there may be
some noise. This is a normal result of
the manufacturing process and does
not indicate a malfunction. If, however,
in a case of abnormal noise, consult
with qualified Sony personnel.
On inspection of light source
related parts
Since the unit uses a laser, when
performing maintenance or inspection
of light source related parts, particular
attention and a safe environment are
necessary. Be sure to consult with
qualified Sony personnel.
On disposing used products
Do not dispose the used products and
general garbage together.
Correctly dispose of used products to
avoid harming the environment or the
health of yourself and others. Follow
the disposal regulations of your area.

On LCD Projector

The LCD projector is manufactured
using high-precision technology. You
may, however, see tiny black points
and/or bright points (red, blue, or
green) that continuously appear on
the LCD projector. This is a normal
result of the manufacturing process
and does not indicate a malfunction.
Also, when you use multiple LCD
projectors to project onto a screen,
even if they are of the same model, the
color reproduction among projectors
may vary, since color balance may be
set differently from one projector to
the next.
On condensation
If the room temperature where the
projector is installed changes rapidly,
or if the projector is moved suddenly
from a cold to a warm place,
condensation in the projector may
occur. As the condensation may cause
malfunction, be careful in adjusting
temperature settings of the air
conditioner. If condensation occurs,
leave the projector turned on for about
two hours before use.
11
GB
Precautions