Table of Contents
Advertisement
1-1. Operating Environment
Operating guaranteed temperature :
Performance guaranteed temperature : +10 dC to +35 dC
Operating humidity :
(relative humidity)
Storage temperature :
Mass (when all options are installed) :
MVS-8000A :
MVS-8000ASF :
Prohibited locations for installation
. Areas where the unit will be exposed do direct sunlight
or any other strong lights.
. Dusty areas
. Areas subject to vibration.
. Areas with strong electric or magnetic fields.
. Areas near heat sources.
. Areas subject to electrical noise.
. Areas subject where is subjected to static electricity.
Ventilation
The inside of the MVS-8000A-C/MVS8000AS-C (MVS-
8000A series hereafter) is cooled by a fan (both sides).
The power supply can be damaged if the exhaust vent
(both sides) and air intake (front panel) are blocked or the
fan is stopped.
Therefore, leave a blank space of more than 10 cm in the
front and both sides of the DVS-9000 series).
1-2. Power Supply
1-2-1. Power Specifications
A switching regulator is used for the power supply of this
unit. The voltage within the range of 100 V to 240 V can
be used without changing the supply voltage.
Power requirements :
Power frequency :
Current consumption (when all options are installed) :
MVS-8000A :
MVS-8000ASF : 7.5 to 3.1 A
MVS-8000A/8000ASF
Section 1
Installation
+5 dC to +40 dC
10 % to 90 %
_20 dC to +60 dC
Approx. 51 kg
Approx. 28 kg
AC 100 to 240 V ± 10 %
50/60 Hz
15 to 6.25 A
m
. As the inrush current at turn-on is a maximum 120 A (at
100 V)/150 A (at 230 V), the capacity of the AC power
source must be commensurate with this load.
If the capacity of the AC power is not adequately large,
the AC power source braker will operate or the unit will
abnormally operate.
. The MVS-8000A contains the two power supply units as
the standard configuration. A maximum of four power
supply units may be installed. When starting up the
MVS-8000A, be sure to turn on the power of two or
more power supply units.
. The MVS-8000ASF contains the single power supply
unit as the standard configuration. A maximum of two
power supply units may be installed. When starting up
the MVS-8000ASF, be sure to turn on the power of one
or more power supply units.
1-2-2. Recommended Power Cord
w
. Use the approved Power Cord (3-core mains lead)/
Appliance Connector/Plug with earthing-contacts that
conforms to the safety regulations of each country if
applicable.
. Use the Power Cord (3-core mains lead)/Appliance
Connector/Plug conforming to the proper ratings (Volt-
age, Ampere).
If you have questions on the use of the above Power Cord/
Appliance Connector/Plug, please contact your local Sony
Sales Office/Service Center.
c
. Never use an injured power cord.
. Plugging the power cord in the AC inlet, push as far as it
will go.
For customers in the U.S.A. and Canada
1 Power cord, 125 V 10 A (2.4 m) : ! 1-557-377-11
1
For customers in the all European countries
1 Power cord, 250 V 10 A (2.4 m) : ! 1-782-929-12
1
AC inlet
AC inlet
1-1
Hide quick links:
Advertisement
Table of Contents
