Table of Contents
Advertisement
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Problem
Solution
Unit will not start.
Check battery installation.
Check battery charging requirements.
Check that lock off is fully pulled back prior to moving main trigger.
Unit shuts down in use.
Charge battery.
Clear debris around spool.
Reduce/limit swath to 330 mm MAX.
Reinstall guard if it has been removed.
Battery won't charge.
Insert battery into charger until red charging light illuminates. Charge up to 8 hours if battery is totally drained.
Plug charger into a working outlet. Refer to Charger Operation for more details.
Check current at receptacle by plugging an appliance.
Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights.
Move charger and appliance to a surrounding air temperature of above 4 °C or below 40 °C.
Appliance runs slowly.
Fully depress the variable speed trigger. The level of trigger depression affects speed.
If appliance still runs slowly, remove battery from appliance.
Check that the spool housing can rotate freely. Carefully clean it if necessary.
Check that the cutting line does not protrude more than approximately 122 mm from the spool. If it does, cut it off so that it just
reaches the line trimming blade.
Trimmer is vibrating.
Make sure both cutting lines are the same length.
Check to see if the spool is properly wound. If spool is broken then replace spool.
TROUBLESHOOTING
English
15
Hide quick links:
Advertisement
Table of Contents
