Table of Contents
Advertisement
[7] ADJUSTMENTS
1. Jogger position adjustment
A. Jogger F/R
1) Staple 5 sheets of A4 or LT paper and check the paper shift (A)
shown in the figure below.
Staple
(A)
2) If the shift (A) is less than 1mm, there is no need to adjust.
3) If the shift (A) is 1mm or greater, adjust as shown in the table below.
Model
Pinter model
DIAG MODE
[FINISHER JOGGER ADJ.]
(Finisher jogger position adjustment)
MFP
SIM 3-6(Built-in finisher jogger position adjustment)
Jogger F
B. Printer model adjustment procedure
1) In the DIAG MODE, select [FINISHER JOGGER ADJ.].
FINISHER JOGGER ADJ.
2) Press [OK] key, and the following display will be shown.
Use [
] key and [
] key to change the adjustments value.
(Adjustment range: 40 - 60)
ADJUST VALUE
3) Change the adjustment value and press OK key, and the stopper will
be turned on and the finisher joggers F/R will move to and stop at the
positions shown in the table below.
Destination
Inch series
LT size alignment position
AB series
A4 size alignment position
Adjustment procedure
Jogger R
50
Jogger position
AR-FN6 ADJUSTMENTS-1
4) When the joggers F/R stop, open the door and load A$/LT paper in
the alignment tray, and check the jogger width visually.
5) When the jogger width is too wide or too narrow, use [
[
] key again to change the adjustments value. Press [OK] key to
shift the jogger to the A4/LT alignment position, and check visually.
The table below shows relationship between the adjustment value and
the jogger width.
Adjustment value
Decreased by 1.
Increased by about 0.375mm.
Increased by 1.
Decreased by about 0.375mm
6) After completion of the adjustment, remove the paper from the
alignment tray and terminate the DIAG MODE.
C. MFP adjustment procedure
1) When the sub code of the simulation is entered, the following display
is shown.
SIMULATION 3-6
FINISHER JOGGER ADJUSTMENT.INPUT VALUE 40-60,AND PRESS START.
SIM 3-6: Jogger position adjustment
2) Enter the adjustment value with [0] - [9] keys and press START key,
and the menu below will be displayed. (Adjustment range: 40 - 60)
SIMULATION 3-6
FINISHER JOGGER ADJUSTMENT.MOVING...
SIM 3-6: Jogger moving
When the stopper is turned on, and finisher joggers F/R move to and
stop at the positions shown in the table below.
Destination
Inch series
LT size alignment position
AB series
A4 size alignment position
3) When the joggers F/R stop, open the door and load A4/LT paper in
the alignment tray, and check the jogger width visually.
4) When the jogger width is too wide or too narrow, use [0] - [9] key
again to change the adjustments value. Press [START] key to shift
the jogger to the A4/LT alignment position, and check visually.
The table below shows relationship between the adjustment value and
the jogger width.
Adjustment value
Jogger width
Decreased by 1.
Increased by about 0.375mm.
Increased by 1.
Decreased by about 0.375mm
5) After completion of the adjustment, remove the paper from the
alignment tray and terminate the simulation.
] key and
Jogger width
50
50
Jogger position
Advertisement
Table of Contents
