AEG MV 10 Operating Instructions Manual page 24

24
▪ No valve adapter required to inflate car tyres.
First remove the cap from the tyre valve.
▪ Open the quick disconnect
automotive valve plug as far as possible onto
the tyre valve. Then close the valve quick
disconnect.
▪ Verify the automotive valve lever plug is firmly
attached to the tyre valve by carefully pulling on
it.
Setting the pressure,
e.g. to 2,0 bar
Image 7
▪ Set the arrow marking on the manometer
adjusting ring to the desired air pressure
5
(see Image 7).
▪ Press the On / Off switch on the compressor
to ( I ). Note: the compressor can be switched
off at any time by setting the compressor switch
to ( O ).
13
▪ Once the air pressure marked on the adjusting
ring has been reached the compressor will
5
automatically switch off.
▪ The completely switch the unit off set the com-
pressor switch to ( O ) and disconnect the unit
from the power supply. Automatic start
warning! If the compressor On / Off switch
is set to ( I ) when reconnecting the unit
to power the compressor will automatically
start and compressed air will be blown through
and attach the
4
5
13
the air hose and the inflating valve and air
suctioned in through the suction valve. Risk
of property damage and personal injury!
▪ Now open the valve quick disconnect and
remove the automotive valve connector from
the tyre valve.
▪ Also check the air pressure with another
pressure gauge to determine the precise
value. If the target pressure is not yet reached
repeat the process.
▪ Then reattach the valve cap onto the tyre valve.
4.3.2 Inflating sporting goods, toys and
recreational products with the air
hose and automotive valve
connector
Do not operate the compressor longer
than 10 minutes, then allow the unit to
cool down for 10 minutes!
▪ First read the product manufacturer's instructions
on inflating and the approved maximum air
pressure before inflating the product.
▪ Open the product's valve cover.
▪ Using the valve quick disconnect
correct valve adapter and press it into the item's
valve. If the valve adapter detaches from the
valve whilst inflating, use your hand to press it
into the valve whilst inflating.
▪ Verify the valve adapter is securely connected to
the valve by carefully pulling on it.
▪ set the arrow on the manometer adjusting ring
to the desired air pressure value.
▪ To switch the compressor on set the compressor
switch to ( I ).
13
Note: the compressor can be switched off at
any time by setting the compressor switch
to ( O ).
▪ Observe and check the firmness of the item
whilst inflating. If the item is already overin-
flated, immediately interrupt the process and
switch the compressor off!
secure the
4
13