IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1.
ELECTRICAL SAFETY
F
WARNING! It is the users responsibility to read, understand and comply with the following:
p
Electricity At Work Act 1989
Health & Safety at Work Act 1974
Important:
DO NOT
DO NOT
DO NOT
a) Note that this saw is double insulated and therefore there is no GREEN/YELLOW earth wire.
b) Connect the BROWN live wire to live terminal L.
c) Connect the BLUE neutral wire to the neutral terminal N.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected, that the cable outer insulation
extends beyond the cable restraint and that the restraint is tight.
Cable extension reels
1.2
GENERAL SAFETY
!
F WARNING!
!
!
!
!
!
!
!
F WARNING!
!
!
!
p
You must
Ensure the unit is correctly wired via a three-pin plug.
To re-wire, connect the brown & blue wires as indicated above. DO NOT connect the brown or blue to the earth terminal.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
If in any doubt about electrical safety, contact a qualified electrician.
NO
TABLE SAW
TS10CZ
Blue
Neutral
Wire
FUSE RATING
THIS PRODUCT MUST BE FITTED
WITH A
13 AMP FUSE
You must
Brown
Live
Wire
Cable
Restraint