Setting The Acp Iv Network Address - LG ACP IV Install/Owner’s Manual

Connecting ACP IV and PC
It is the case of installing AC Manager IV in a
separate PC and connecting ACP IV and PC
directly.
In such case, Ethernet cable shall be connect-
ed as a cross cable.
Use Ethernet cable (cross cable) to connect to
LAN port of the ACP IV.
! CAUTION
Ethernet cable types
• You must distinguish if the Ethernet
cable to connect is a direct cable or a
cross cable.
• Also, connect after checking the exis-
tence of problem in the cable using LAN
tester.
Setting the ACP IV network
address
After connecting the ACP IV to various
devices via the cable, the network environ-
ment of the ACP IV should be set by driving
the ACP IV. The following information should
be set for using the ACP IV.
• IP address of the ACP IV
• Gateway address
• Net mask
Connection with
hub
Direct cable
Direct connection
Before configuring the ACP IV envi-
with PC
Cross cable
ronment
The network environment of the ACP IV can
be set by the LCD and the buttons at the front
side of the ACP IV.
The current ACP IV information and the menu
are displayed on the LCD, and the menu can
be changed and selected by pressing and
button
(▲, ▼, ◀, ▶) buttons.
INSTALLING ACP IV
! CAUTION
Setting the network environment informa-
tion
If the above information is not entered,
the communication error may be occurred
or it may be impossible to control by the
ACP IV. So, be careful to correctly input.
and Up/Down/Left/Right
PACP4B000 PACP4B000
13