Overheating Protection; Maintenance And Cleaning; Rowi Electronics Gmbh Warranty - Silvercrest SEK 2000 A1 Operation And Safety Instructions

button. The symbols and
D
and the set time is displayed.
- SET UP
After you have set the timer, press this button to set
whether to turn the appliance on or off. The symbols
or on the display indicate the current setting.
5 6
- Adjust brightness
Push this button to set various heating levels. The stair
display on the display shows the currently set step.
H
- Setting the heating levels
Push this button to set the 2 heating levels.
Press once = 900 W, press twice = 1850 W.
To set the temperature during heating, press the "+"
or "-" keys. The adjustable temperature range is
between 15 and 30°C.
Note: When setting the temperature, please bear in
mind that the appliance does not heat if the desired
temperature is equal to or lower than the ambient
temperature. To heat, the set temperature must be at
least 1°C higher than the ambient temperature. This
is displayed automatically when the appliance is
switched on.

Overheating protection


For your safety, this appliance has overheat protection.
If the temperature inside the appliance becomes too
high, it switches off automatically:
1. Pull out the mains plug.
2. Allow the appliance to cool for at least 20
minutes.
3. Check that the ventilation grilles
and clean them with a soft, dry cloth.
4. Now restart the appliance. After that, you can
continue operating it normally.
If no cause can be found and the error occurs
repeatedly, have the appliance repaired or shut it
down.
light up on the display
H
are clear
11

Maintenance and cleaning


CAUTION! DANGER DUE TO ELECTRIC
SHOCK! Before cleaning, unplug the mains plug
from the mains socket and allow appliance to
cool completely.
Clean the outside of the appliance with a soft
dry cloth. Never use liquids, especially those
containing petrol, or cleaning agents, as these
will damage the appliance.
Regularly remove dust and dirt from the
ventilation grilles using a vacuum cleaner.

ROWI Electronics GmbH warranty


Dear Customer,
This appliance has a 3-year warranty valid from the date
of purchase. If this product has any faults, you, the buyer,
have certain statutory rights. Your statutory rights are not
restricted in any way by the warranty described below.
Warranty conditions
The validity period of the warranty starts from the
date of purchase. Please keep your original receipt
in a safe place. This document will be required as
proof of purchase.
If any material or production fault occurs within three
years of the date of purchase of the product, we will
either repair or replace the product for you at our
discretion. This warranty service is dependent on you
presenting the defective appliance and the proof of
purchase (receipt) and a short written description of
the fault and its time of occurrence.
If the defect is covered by the warranty, your product
will either be repaired or replaced by us. The repair
or replacement of a product does not signify the be-
ginning of a new warranty period.
Warranty period and statutory claims for defects
The warranty period is not prolonged by repairs effect-
ed under the warranty. This also applies to replaced
and repaired components. Any damage and defects
present at the time of purchase must be reported im-
mediately after unpacking. Repairs carried out after
expiry of the warranty period shall be subject to a fee.
GB/IE/NI 15