Door Storage; Drawers - Kenmore 596.52673200 Use & Care Manual

Freezer Features
! CAUTION I
To avoid properly damage, observe the following:
• Do not force ice maker arm down or up
• Do not place or stere anything in ice storage bin
[
WARNING
]
To avoid possible injury, including death, do not place glass
items in ice cream shelf Glass objects may shatter or
explode if exposed to extreme cold
Primary Features
r •
Automatic Dispensing Ice Maker
This ice maker creates the ice used in the dispensing
system
Using Ice Maker for the First Time
• Confirm ice bin is in place
and ice maker arm is down
• After freezer section reaches
between 0 ° to 2°F (-18 ° to
-17 ° C) ice maker fills with
water and begins operating
Q
Allow approximately 24 hours after installation to
receive first harvest of ice
Discard ice created within first 12 hours of operation to
verify system is flushed of impurities
Operating Instructions
Confirm ice bin is in place and ice maker arm is down
, After freezer section reaches 0° to 2°F (-18" to -!7 ° C),
ice maker fills with water and
begins operating You will have a
complete harvest of ice
approximately every 3 hours
Stop ice production by raising ice
maker arm until click is heard
Ice maker will remain in the off position until arm is
pushed down
Drawers
gce Cream Shelf
Ice cream shelf provides a space for items to be
chilled or frozen quickly
, To remove, lift ice cream shelf
from ice bin rails and pull
straight out
. To install, fit shelf over top of
ice maker and lower onto ice
bucket rails
Storage Bin
The ice storage bin is located below the automatic
dispensing ice maker
To remove and install ice storage bin:
• To remove bin, remove ice cream shelf
Raise ice maker arm to deactivate ice
maker Lift front of bin and pull out
to its full extension Lift up front of
bin and remove
. To install, slide bin into rails below ice maker until bin
locks into place Drop ice maker arm to activate ice
maker, and replace ice cream shelf
IMPORTANT: Ice bin must be
locked in proper place for proper _/_'_
ice dispensing If freezer door
does not close, bin is not in proper
location Turn auger driver counterclockwise (as shown)
to properly align ice bin with back of unit
i m
Shellves
Freezer Shelf
To remove and install clip-mounted shelves:
,A
To remove, pull shelf from wall ____
mounting clips and pull left side
of shelf out of wall mounting
holes
To install, place shelf in mounting hole and attach to
wall mounting clips
To remove and install rail-mourl
To remove snap right side of
shelf from cabinet railing and
remove from wall mounting
clips
To install, replace shelf in
wall mounting clips Be sure back edge of shelf is
flush with back of cabinet and snap shelf into cabinet
railing
Door Storage
i ii i iii iiii i i iiii iii
Door Buckets
t Refer to refrigerator section for instructions J
t.3