Troubleshooting; Warranty; Parts Replacements - Craftsman MIDORO MO56 Installation Manual

Warranty.

Troubleshooting.

WARNING: Failure to disconnect power supply
prior to troubleshooting any wiring issues may
result in serious injury.
Problem: Fan fails to operate.
Solutions:
1. Check wall switch to fan/wall control.
2. Check to be sure wall control (optional use) is wired
properly.
3. Check to be sure fan is wired properly.
4. Learning process between fan, handheld remote control
and, if applicable, wall control may not have been successful
and code was not activated. Turn off power and repeat
instructions in Section 11 (page 10).
5. Check that red light on handheld remote control turns on
when a button is pressed indicating that the battery is good.
Problem: Light kit not lighting.
Solutions:
1. Check wall switch to fan/wall control.
2. Check that bulb is installed correctly.
3. Check that wires in canopy are wired properly.
4. Verify that molex connections in light kit fitter are
connected properly.
5. Learning process between fan, handheld remote control
and, if applicable, wall control may not have been successful
and code was not activated. Turn off power and repeat
instructions in Section 11 (page 10).
Problem: Fan operates but light fails.
Solutions:
1. Check that bulb is installed correctly.
2. Check that wires in canopy are wired properly.
3. Replace defective bulb with same type of bulb.
4. Verify that molex connections in light kit fitter are
connected properly.
Problem: Fan and light fail to operate with wall control
(optional) and/or handheld remote control.
Solutions:
1. Check battery power in handheld remote control.
2. Learning process between fan, handheld remote control
and, if applicable, wall control may not have been successful
and code was not activated. Turn off power and repeat
instructions in Section 11 (page 10).
3. If using optional wall control, check that battery in wall
control is still good.
Problem: Lighting source (up-light, down-light or both) not
functioning.
Solution:
Wattage Limiting Device has interrupted the flow of
electricity to the light source. Ensure bulbs total no more than
190W in the light source.
Problem: Fan wobbles.
Solutions:
1. Use the balancing kit in one of the hardware packs. If no
blade balancing kit is provided, please call Customer Support
to request one.
2. Check to be sure set screw(s) on motor housing yoke is
(are) tightened securely.
3. Check to be sure set screw on hanging ball is tightened
securely.
page 11