Fuses; Optional Lighting; Backlapping The Cutting Units - Toro Reelmaster 5200-D Operator's Manual

posts and cable connectors with Grafo 112X (skin-over)
grease (Toro Part No. 505-47) or petroleum jelly to prevent
corrosion.

Fuses

There are 4 fuses in the machines electrical system. They
are located below control panel (Fig. 71 and 72).
1
Figure 71
1. Fuses
Figure 72

Optional Lighting

Important
If optional lighting is be added to the
traction unit, use the following schematic and part numbers
to prevent damage to the traction units electrical system.
SCHEMATIC FOR OPTIONAL LIGHTING
Black
Red
Orange
2
Switch
Switch*
Toro Part No. 75–1010
Honeywell Part No. 1TL1–2
Black, red and orange wires are located in control con-
sole.
Add 10 Amp fuse to fuse block at location shown
* Punch out in control panel provided for switch installa-
tion
Note: Make sure a good ground is achieved to prevent
damage to traction unit.

Backlapping the Cutting Units

Warning
Contact with the reels or other moving parts can
result in personal injury.
• Keep fingers, hands, and clothing away from the
reels or other moving parts.
• Never attempt to turn the reels by hand or foot
while the engine is running.
Note: When backlapping, the front units all operate
together, and the rear units operate together.
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking brake,
and move the Enable/Disable switch to disable position.
2. Unlock and raise the seat to expose controls.
3. Make initial reel to bedknife adjustments appropriate
for backlapping on all cutting units which are to be
backlapped.
4. Start engine and run at idle speed.
47
To Lights w/external ground
To Lights
30
30
85
3
86
Relay
Relay
Toro Part No. 70–1480
Bosch Part No. 0–332–204