Table of Contents
Advertisement
BASIC OPERATION
REDIAL
Handset On The Base
1) Pick up the handset and press
2) Listen for the dial tone.
3) Press
.
REDIAL
OUT OF RANGE
During a call, as you begin to move too far from the base unit, the
noise increases. Then, you should move closer to the base unit. If
you travel out-of-range, your call terminates.(See page 19
"Interference or static")
CALL WAITING
To use this feature, you must subscribe to the Call Waiting Service.
1
When you hear a call-waiting tone during your conversation on the
phone, simply press
2
To return to the first caller, press
NOTE:
Pressing
FLASH
current caller.
HANDSET EARPIECE VOLUME SETTING
To adjust the earpiece volume, press
HANDSET RINGER VOLUME SETTING
To adjust the ringer volume, press
mode.
NOTE:
When the handset is on the base, the handset ringer volume is disabled.
18
.
TALK
.
FLASH
without receiving a Call Waiting signal may disconnect the
Handset Off The Base
Press
, then press
REDIAL
again.
FLASH
(
or
VOL/RING
(
or
VOL/RING
.
TALK
) during a call.
) during standby
Advertisement
Table of Contents
