Trmt; Trmt-Miss - Cisco ONS 15327 User Documentation

Chapter 14 Alarm Troubleshooting
This alarm also occurs on a port that has previously been operating without alarms if someone switches
or removes the DS-3 cables or optical fibers that connect the ports. This TIM-P occurrence is usually
accompanied by other alarms, such as LOS, UNEQ-P, or PLM-P. In this case, reattach or replace the
original cables/fibers to clear the alarm.
Procedure: Clear the TIM-P Alarm
Login to the circuit source node and select the Circuits tab.
Step 1
Select the circuit reporting the alarm, then click Edit.
Step 2
At the bottom of the Edit Circuit window, check the Show Detailed Map box.
Step 3
On the detailed circuit map, right-click the source circuit port and select Edit Path Trace from the
Step 4
shortcut menu.
On the detailed circuit map, right-click the drop/destination circuit port and select Edit Path Trace from
Step 5
the shortcut menu.
Compare the New Transmit String and the New Expected String entries in the Path Trace Mode dialog
Step 6
box.
Step 7 If the strings differ, correct the Transmit or Expected strings and click Apply.
Step 8 Click Close.

14.4.122 TRMT

•
A facility-termination equipment transmit failure (TRMT) alarm occurs when there is a transmit failure
on the XTC card because of an internal hardware failure. The card must be replaced.
Procedure: Clear the TRMT Alarm on the XTC-14 Card
Replace the XTC-14 card reporting the failure.
Step 1
Note
Login to http://www.cisco.com/TAC for more information or call the Cisco Technical Assistance Center
Step 2
(1-800-553-2447) to discuss the failed card and possibly open a returned materials authorization (RMA).

14.4.123 TRMT-MISS

•
June 2002
Major, Service-Affecting
When you replace a card with an identical type of card, you do not need to make any changes to
the database.
Major, Service-Affecting
Cisco ONS 15327 User Documentation, R3.3
Alarm Procedures
14-83