Table of Contents
Advertisement
Don't locate in shade of obstructing objects (Box, antenna, etc.).
Next, connect the antenna to the arrestor with a coaxial cable.
The following antennas are recommended: GPA-014B or GPA-017S manufactured by Furuno
Electric Co., Ltd. The specifications for and dimensions of these antennas are described in
Appendix C.
The antenna should be fixed to a support pole with Debe clamps and U bolts. An example
installation of the Furuno Electric antenna, using the accompanying clamps, is shown in Figures
6.3.1, 6.3.2 and 6.3.3.
Wind the tape to cover the whole of
junction and U-shaped gap.
Leave the connector slightly loose so
that no excessive force is applied.
Connector junction.
Insulation prevention measure
(Autofusion tape, vinyl tape or water-proof cap)
Figure 6.3.1
Pipe
An Example of Installation, Using GPA-017S for Antenna
13
Don't locate in shade of
obstructing objects
(Box, antenna, etc.)
Antenna
Parker clamp
Auxiliary
bracket
Support pole (φ25 to 70)
Convex
Antenna cable
6 F 2 S 0 7 3 8
mounting
Advertisement
Table of Contents
