Changing The Seat Suspension; During Operation; During Operation Safety - Toro Z Master Professional 5000 Series Operator's Manual

Changing the Seat
Suspension
The seat adjusts to provide a smooth and comfortable
ride. Position the seat where you are most
comfortable.
To adjust, turn the knob in front either direction to
provide the best comfort
Figure 14
1. Seat-suspension knob
(Figure 14).

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; slip-resistant, substantial footwear; and
hearing protection. Tie back long hair and do not
wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
g019768
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Do not mow near drop-offs, ditches, or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
gives way.
•
Stop the blades whenever you are not mowing.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Disengage the drive to the cutting unit and shut
off the engine before adjusting the height of
cut (unless you can adjust it from the operating
position).
•
Never run an engine in an area where exhaust
gases are enclosed.
•
Never leave a running machine unattended.
19