Panasonic ET-PEN100 Operating Instructions

Names
Tip with touch sensor
Bofore using the pen
Install batteries.
Installing and Removing Batteries
1. Rotate as shown in the figure.
2. Install 2 AAA/R03 or AAA/LR03 type batteries.
* Remove the batteries in
the reverse order of installation.
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households)
This symbol on the products and/or accompanying documents means that used electrical and
electronic products should not be mixed with general household waste. For proper treatment,
recovery and recycling, please take these products to designated collection points, where
they will be accepted on a free of charge basis.
Alternatively, in some countries you may be able to return your products to your local retailer
upon the purchase of an equivalent new product.
Disposing of this product correctly will help to save valuable resources and prevent any
potential negative effects on human health and the environment which could otherwise arise
from inappropriate waste handling. Please contact your local authority for further details of
your nearest designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national
legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or
supplier for further information.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for
the correct method of disposal.
Panasonic Corporation
Web Site : https://panasonic.net/cns/projector/
© Panasonic Corporation 2012
Thank you for purchasing this Panasonic product.
• Before using this product, please read this
instructions and "LightPenII: Operation Manual"
completely, and save this manual for future use.
How to use the pen
While pressing the tip against a hard screen,
the tip of the pen and the LED for the internal
infrared ray will both light. This is sensed by the
infrared ray sensor on the front of the projector,
Power button
and the location of the tip of the pen is detected.
1) Press the power button to turn the power on.
2) Place the tip of the pen anywhere on the
3) By pressing the tip against a hard screen,
Attention
Since there is a touch sensor inside the tip of the pen,
pushing or bending the tip will consume battery power.
In order to prevent unnecessary battery consumption
when not in use, press the power button to turn the
power off. (Press the tip of the pen to confirm that the
LED does not light.)
EEE Yönetmeliğine Uygundur.
EEE Complies with Directive of Turkey.
Operating Instructions
Interactive Pen
Model No.
screen.
you can drag. In pen mode, you can draw
lines.
Commercial Use
ET-PEN100
ENGLISH
Printed in Taiwan
1LG6P1P1022-- (IJDV)
TQZJ711-1