Storage; Toro Service Support - Toro 1800 Power Curve Operator's Manual

8. Slide the belt over the motor shaft pulley (Fig. 22).
9. When tightening the bolt, the bolt head and the
washers must be flush against the small pulley. Torque
the bolt to 25 to 30 in-lb. Do not overtighten the bolt.
10. Slip the large belt over the small pulley (Fig. 21).
Refer to step 4 through 6 of Replacing the Large Belt
on page 11.

Storage

1. Run the snowthrower for a few minutes to melt away
any snow on the snowthrower.

Toro Service Support

If your snowthrower requires service or maintenance, your nearest Toro Master Service Dealer is the best dealer to assist
you. Refer to the "Yellow Pages" of your local telephone directory in the section titled "Lawn Mowers." Toro Master
Service Dealers are listed under the Toro trademark. If you need help locating a Toro Master Service Dealer near you, call
1-800-421-9684 for assistance.
2. Disconnect the extension cord from the snowthrower.
3. Examine the extension cord thoroughly for signs of
wear or damage. Replace it if it is worn or damaged.
4. Examine the snowthrower thoroughly for worn, loose,
or damaged parts. For repairing or replacing parts,
contact your local Authorized Service Dealer for
assistance.
5. Store the extension cord with the snowthrower.
6. Store the snowthrower in a clean, dry place. Cover it
to provide protection.
13