Related Manuals for Electrolux QuickDry N1130
Summary of Contents for Electrolux QuickDry N1130
- Page 1 Operating manual Tumble dryer QuickDry Type N1130 438 9096-00/EN 2011.11.03 Operating manual in original language...
-
Page 3: Table Of Contents
Contents Contents 1 Safety Precautions ......................5 2 Program description ......................7 2.1 General........................7 2.2 Program description ....................7 2.3 Load..........................8 3 Handling ..........................9 3.1 To start the machine ....................9 3.2 Additional functions ....................10 3.3 When program has ended ..................11 4 Error codes......................... -
Page 5: Safety Precautions
Safety Precautions 1 Safety Precautions The machine is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the machine. - Page 6 Safety Precautions All external equipment which is connected to the machine must be CE/EMC-approved and connected using an approved shielded cable. In order to prevent damage to the electronics (and other parts) that may occur as the result of condensation, the machine should be placed in room temperature for 24 hours before being used for the first time.
-
Page 7: Program Description
Program description 2 Program description 2.1 General The machine is equipped with a number of programs adapted to the range of use to which the machine is intended. It is recommendet to follow the care labelling of the garment as far as possible. For best possible drying result it is advisable to dry garments of the same quality for each drying cycle. -
Page 8: Load
Program description 2.3 Load For an optimal result it is recommended to load the machine to half. The maximum load is 6 kg. -
Page 9: Handling
Handling 3 Handling Load the goods into the machine according to recommendations and close the door. Make sure the filter is clean and clean if necessary. fig.7361 ① 3.1 To start the machine Select the desired program by turning the control knob. There are two types of programs, automatic programs and time programs. -
Page 10: Additional Functions
Handling 3.2 Additional functions Pause It is possible to pause an ongoing program. Press the control knob. A meny will appear on the display. Select PAUSE by turning the control knob and press the control knob to activate. For some machines it is also possible to pause directly when pressing the control knob. When pressing the control knob again the program will continue. -
Page 11: When Program Has Ended
Handling 3.3 When program has ended Note! For the best possible drying result it is important to empty the machine as soon as the program has ended. If the machine is not emptied as soon as the program has ended the drum will rotate in short intervalls in order to keep the goods from being wrinkled. -
Page 12: Error Codes
Error codes 4 Error codes A fault in the program or in the machine is indicated by an error code on the display. Some of these error codes can be solved easily without contacting service personnel. Error Text Cause/Action code DRYING ERROR WITH 12:11 The longest permitted RMC time has been exceeded. -
Page 13: Maintenance
Maintenance 5 Maintenance 5.1 General It is the responsibility of the owner of the machine/the laundry manager to make sure that the following maintenance is performed. Note! Lack of maintenance may deteriorate the performance of the machine and may cause damage to components. -
Page 14: Every Day
Maintenance 5.2 Every day Check that the machine does not operate with the door or filter door open, if so, the machine must be placed out of order until repairs are made. Note! Contact qualified service personnel to disconnect power from the affected machine. Clean the door, door gasket and other exterial parts. -
Page 15: Fresh Air Intake
Maintenance 5.3 Fresh air intake At regular basis, check that the fresh air intake on the front of the machine is not clogged by lint and dust or otherwise blocked. Clean with a vacuum cleaner. fig.7386 ⑤ 5.4 Machines with residual moisture control (RMC) At regular basis, wipe off/clean drum and lifters with citric acid (Acidum citricum). -
Page 16: Maintenance To Be Carried Out By Qualified Service Personnel
Maintenance 5.6 Maintenance to be carried out by qualified service personnel Contact qualified service personnel to perform the following maintenance: After 1600 hours of operation or once a year, whichever comes first: • Clean the fan, the exhaust duct and the fresh-air intake to the room •... - Page 19 Skrotning av maskin När maskinen inte längre skall användas måste den lämnas till en återvinningsstation för destruktion. Många detaljer i maskinen går att återanvända, men den innehåller även annat material som måste tas om hand på ett korrekt sätt. Lämna därför aldrig maskinen eller delar av maskinen i hushållsavfallet, eftersom det kan leda till hälsorisker eller skador på...
- Page 20 Electrolux Laundry Systems Sweden AB 341 80 Ljungby, Sweden www.electrolux.com/laundrysystems Share more of our thinking at www.electrolux.com...