Set Clock; Demonstrate The Unit's Features; Adjust Brightness Of Display Panel; Turn On Or Off Led Light - Philips MCM7000/12 User Manual

a
b
c
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.

Set clock

1
In standby mode, press CLOCK for three
seconds to activate clock setting mode.
» [CLOCK SET] scrolls on the display,
then the time format [24H] or [12H]
is displayed.
2
Press VOL +/- to select 24H or 12H, then
press CLOCK to confirm.
»
The hour digits begin to blink.
3
Press VOL +/- to set hour, then press
CLOCK again.
»
The minute digits begin to blink.
4
Press VOL +/- to set minute.
5
Press CLOCK to confirm the clock
setting.
Note
•
If no button is pressed in 90 seconds, the
system exits clock setting mode automatically.
12 EN
Demonstrate the unit's
features
1
In the standby mode, press
"DEMO ON" is displayed.
»
Available features are displayed one
by one.
• To turn off the demonstration, press
again.
Adjust brightness of display
panel
Press DIM repeatedly to select different
brightness levels.

Turn on or off LED light

1
In power-on mode, press and hold DIM
to turn on or off the LED light at the
bottom of the unit and at the volume
knob.

Turn on

1
Press .
»
The unit switches to the last selected
source.

Switch to standby mode

To switch the system to Eco Power Standby
mode:
In standby mode, press and hold
seconds.
» [ECO POWER] (Eco power) scrolls on
the display, then the backlight turns off.
until
for 2