Table of Contents
Advertisement
Maintenance & Safety (See 8)
CD player and CD handling
•
If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
•
The lens of the CD player should never be
touched!
•
Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the
lens but leave the set in a warm environment
until the moisture evaporates.
•
Always close the CD-tape door to avoid dust
on the lens.
•
To clean the CD, wipe in a straight line from
the center towards the edge using a soft, lint-
free cloth. Do not use cleaning agents as they
may damage the disc.
•
Never write on a CD or attach any stickers
to it.
Tape deck maintenance
To ensure quality recording and playback of
the tape deck, clean parts A, B and C as
shown, once a month. Use a cotton bud
slightly moistened with alcohol or a special
head cleaning fluid to clean the deck.
1 Open the cassette holder by pressing
STOP•OPEN 9/.
2 Press PLAY 1 and clean the roller C.
3 Press PAUSE 8 and clean the heads A,
and the capstan B.
4 After cleaning, press STOP•OPEN 9/.
➜ Cleaning of the heads can also be done
by playing a cleaning cassette through
once.
Safety information
•
Place the set on a flat, hard and stable surface
so that the system does not tilt.
•
Where the MAINS plug or an appliance
coupler is used as the disconnect device, the
disconnet device shall remain readily
operable.
•
Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
•
The apparatus shall not be exposed to
dripping or splashing.
•
Adequate ventilation with a minimum gap of
15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary
to prevent heat build-up.
•
Do not cover the ventilation openings with
items such as newspapers, table-cloths,
curtains, etc.
•
No objects filled with liquids, such as vases,
shall be placed on the apparatus.
•
No naked flame sources, such as lighted
candles, should be placed on the apparatus.
•
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
•
Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.
•
To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.
Advertisement
Table of Contents
