Troubleshooting - Philips AZ1605/17 User Manual

TROUBLESHOOTING

WARNING
Under no circumstance should you try to
repair the set yourself as this will
invalidate the warranty.
Problem Possible cause
No sound, VOLUME is not adjusted.
no power
Headphone is connected.
Power cord is not securely connected.
Batteries are dead.
Batteries are inserted incorrectly.
Trying to change over from AC power to
battery supply without removing the plug.
No reaction to Electrostatic discharge.
operation of any keys
Poor radio reception Weak radio signal.
Interference caused by vicinity of electrical
equipment like TVs, computers, engines, etc..
no or E indication
The CD is badly scratched or dirty.
No CD is inserted.
The CD is inserted upside down.
The laser lens is steamed up.
The CD skips tracks The CD is damaged or dirty.
SHUFFLE
Poor cassette Dust and dirt on the heads, capstans or
sound quality pressure rollers.
Use of unsuitable cassette types
(METAL or CHROME) for recording.
Recording does Cassette tab(s) may be snapped off.
not work
or is active.
PROGRAM
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
Solution
Adjust volume.
Disconnect headphone.
Connect power cord properly.
Insert fresh batteries.
Insert batteries correctly.
Remove the power plug from the
unit's AC MAINS inlet.
Disconnect the set from power supply,
reconnect after a few seconds.
Direct the antenna for optimum
reception.
Keep the radio away from electrical
equipment.
Replace or clean the CD.
Insert a CD.
Insert CD with label upwards.
Wait until the lens has cleared.
Replace or clean the CD.
Switch off
SHUFFLE
Clean heads, capstans, and pressure
rollers.
Only use NORMAL type cassettes for
recording.
Apply a piece of adhesive tape over
the aperture.
or play.
PROGRAM
17