Table of Contents
Advertisement
1.
vertical shaft spring
2.
Handle valve
3.
Hexagon shaft
4.
mounting/demounting head
5.
Jaw
6.
Turntable
7.
Pedal label.
8.
column tilt pedal
9.
Clamp pedal
10.
tyre bead braking pedal
11.
turn table pedal
12.
Horizontal arm
13.
clamp turntable cylinder
14.
column
15.
Blade handle
16.
Bead breaking cylinder
17.
Bead breaking arm
18.
Bead breaking blade
5.3.
column installation.
5.3.1.
According to the requirements shown in fig.1, position the main body of the machine. Unpack the accessory box and take out the
rotation shaft assembly fig.3.1, and push out shaft assembly fig.3.2. Clean the assembly and lubricate with oil.
fig.3
5.3.2.
Remove the fixing screw fig.4.1, remove the side panel fig.4.2.
5.3.3.
Remove the fixing screw fig.4.3, remove the tool box.
fig.5
5.3.4.
Lift up the column (two man lift) and insert the PU hose fig.5.1. at the bottom into the hole fig 5.2. on the top of the body. Adjust the
position of the column to make the rotation shaft bushing fig.6.1 align with bearings fig.6.2. Remove the nut and washer at the one
end of the rotational shaft assembly fig.3.1. Push the shaft through the bushes and fit the washer and tighten nut to a torque of
70nm.
© Jack sealey limited
fig.2
Original Language Version
fig.4
fig.6
tc10 | issue 1 02/02/18
Advertisement
Table of Contents
