Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of plug proceed as follows: Remove fuse cover and fuse. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. Refit the fuse cover.
Page 4
English Congratulations on your purchase and welcome to Philips! To fully benifit from the support that Philips offers, register your product at www.philips.com/welcome Supplied Accessories – 1 x AC/DC certified switching adapter (Model No.: ED4120090060A, Input: 230V~ 50Hz, 70mA, Output: 9V, 600mA) –...
Power Supply Using AC power 1 Check if the power voltage, as shown on the type plate located on the rear of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the supplied switching adapter to the wall socket and the DC jack on the set.
Basic Operation Basic operation 1 Connect the supplied switching adapter to the wall outlet and the DC jack on the set or insert batteries as described in Power Supply. • Turn the source selector to TUNER to select tuner mode. •...
Safety & Maintenance (See 2) Safety & maintenance information • Place the set on a flat, hard and stable surface so that the system does not tilt. • Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invali- date the guarantee.
Page 9
Meet Philips at the Internet http://www.philips.com AE2730 Printed in China PDCC-ZC-0743...