How To Set Up The Stapler Finisher - Brother SF-4000 How To Set Up

[ English ]

How to Set Up the Stapler Finisher

CAUTION
• The printer must be powered off before attaching the Stapler Finisher.
• Be careful not to pinch your fingers when you install or remove the Stapler
Finisher unit.
• When connecting or disconnecting the Stapler Finisher, face the printer and
use the handholds on either side to grasp the Stapler Finisher firmly.
DO NOT try to lift the Stapler Finisher using any other parts or openings, as
this could cause injury or damage to the Stapler Finisher.
• DO NOT put your hands on the moving parts shown in the illustrations. Doing
this may cause injury to your fingers.
• Remove the Stapler Finisher before moving the printer.
DO NOT lift or move the printer when the Stapler Finisher is connected. The
Stapler Finisher is not securely attached to the printer and moving it may
cause injury or damage to the printer.
Connect the Stapler Finisher to your printer and turn the printer on
1
(HL-L63XX and HL-L64XX series only) Update your printer's firmware and driver
2
• Firmware: Go to support.brother.com/up1 and check for the latest firmware release.
• Driver: Go to support.brother.com and search your model's Downloads page.
Configure your printer driver to use the Stapler Finisher
3
A • For Windows 10, Windows Server 2016, and Windows Server 2019:
Click
View devices and printers.
• For Windows Server 2012 R2:
Click Control Panel on the Start screen. In the Hardware group, click View devices and printers.
• For Windows 8, Windows 8.1, and Windows Server 2012:
Move your mouse to the lower right corner of your desktop. When the menu bar appears,
click Settings > Control Panel. In the Hardware and Sound (Hardware) group, click
View devices and printers.
• For Windows 7 and Windows Server 2008 R2:
Click the
• For Windows Vista and Windows Server 2008 (HL-L63XX and HL-L64XX series only):
Click the
• For Windows XP and Windows Server 2003 (HL-L63XX and HL-L64XX series only):
Click Start > Printers and Faxes.
B Right-click the Brother XXXX series or Brother XXXX series Printer icon (where XXXX is your model
name) and select Printer properties (Properties), and Brother XXXX series if necessary. The printer
properties dialog box appears.
C Click the Device Settings tab, and then click Auto Detect. When the Stapler Finisher has been detected,
click Apply. (Under certain conditions Auto Detect may not be available. If this occurs, manually add the
Stapler Finisher: Under Available Options select Stapler Finisher, click Add, and then click Apply.)
NOTE • The Macintosh printer driver is not supported.
• All referenced trademarks and registered trademarks are the property of their respective companies.
• For more information about the Stapler Finisher unit, see the Stapler Finisher Online User's Guide at
support.brother.com/manuals.
> Windows System > Control Panel. In the Hardware and Sound group, click
(Start) button > Devices and Printers.
(Start) button > Control Panel > Hardware and Sound > Printers.
- 5 -