Panasonic KX-NCP Series Important Safety Lnstruct1Ons page 3

PSQX5100WA-VB.fm Page 3 Friday, September 23, 2011 12:44 PM
For the PBX
• If damage to the unit exposes any internal parts, disconnect the power supply cord
immediately and return the unit to your dealer.
• To prevent fires, electric shock, injury, or damage to the product, be sure to follow
these guidelines when performing any wiring or cabling:
a) Before performing any wiring or cabling, unplug the product's power cord from
the outlet. After completing all wiring and cabling, plug the power cord back
into the outlet.
b) When laying cables, do not bundle the product's power cord with the power
cords of other devices.
c) Do not place any objects on top of the cables connected to the PBX.
d) When running cables along the floor, use protectors to prevent the cables from
being stepped on.
e) Do not run any cables under carpeting.
• Unplug the unit(s) from the AC outlet if the system emits smoke, an abnormal smell
or makes unusual noise. These conditions can cause fire or electric shock. Confirm
that smoke has stopped and contact an authorised Panasonic Factory Service
Centre.
• Do not insert objects of any kind into this product, as they may touch dangerous
voltage points or short out parts that could result in a fire or electric shock.
• Be careful not to drop any components. Dropping components may damage them
or cause an injury.
[For KX-NCP Series PBX Users Only]
• Only use the 19-inch rack mounting equipment (attachment bracket, screws)
included with the PBX.
•
Make sure that the AC outlet is properly earthed, then securely connect the 3-pin AC
plug including the earthed pin.
[For KX-TDE Series PBX Users Only]
• Danger of explosion exists if a battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the battery manufacturer. Dispose of
used batteries according to the manufacturer's instructions.
• Make sure that the wall that the shelf will be attached to is strong enough to support
the shelf. If not, it is necessary for the wall to be reinforced.
• Only use the wall-mounting equipment (anchor plugs, screws, metal bracket)
included with the PBX.
• Wait at least 20 s after disconnecting the AC supply and backup battery supply
before installing or replacing the power supply unit.
CAUTION
For All Telephone Equipment
• The product should be kept free of dust, moisture, high temperature (more than
40 °C) and vibration, and should not be exposed to direct sunlight.
3