Table of Contents
Advertisement
Cable-management arm
Step 12. If you removed a console switch from behind the console unit, reinstall it now.
Step 13. Reconnect to the server or console switch all cables that you removed in step Step 2 on page 32.
Step 14. Connect power to the display.
Replacing the slide-rail assemblies
Note: To make sure that the slide-rail assemblies fit correctly, replace both the outer and inner slide-rails at
the same time.
To replace the outer and inner slide-rails for the console unit, complete the following steps:
Step 1.
If a console switch is installed behind the console unit, remove the console switch from the rack.
Step 2.
Turn off the display and disconnect the power cord from the short jumper cord on the cable-
management arm from the electrical outlet or power distribution unit (PDU). Disconnect from the
server or console switch any cables that are connected to the console unit (keyboard-and-mouse,
video, and power cables).
Step 3.
Close the flat-panel display.
Step 4.
If you installed the optional flat-head stabilizer screws in the top hole on the front of each slide-rail,
remove them and set them aside.
34
1U 18.5-inch Standard Console Installation and Maintenance Guide
Thumbscrew
Hide quick links:
Advertisement
Table of Contents
