Working With Bop - Siemens Sinamics G120P Instruction Manual

2.2 Working with the BOP-2
The BOP-2 is equipped with seven buttons. For setup and parameterization only the UP and DOWN, OK
and ESC buttons are relevant. The ON, OFF and HAND/AUTO keys are needed for local operation.
Operator Panels BOP-2 and IOP-2:
28
2
1 4
3
5 6 7

Working with BOP-2

1 ESC key – takes you back to the
previous screen
Up key – changes selection
2
3 Down key – changes selection
4 OK key – confirms selection
5 OFF key – stops the motor in the
manual mode
6 HAND / AUTO key – switches the
command source between HAND and
AUTO mode
7 ON / RUN key – starts the motor in the
manual mode