Clutch Pedal; Automatic Transaxle (At) Fluid - Suzuki Ciaz Owner's Manual

INSPECTION AND MAINTENANCE

Clutch Pedal

Fluid Control Clutch
EXAMPLE
MAX MAX
Check the clutch pedal for smooth opera-
tion and clutch fluid level from time to time.
If clutch dragging is felt with the pedal fully
depressed, have the clutch inspected by
your authorised Maruti Suzuki workshop. If
the clutch fluid level is near the "MIN" line,
fill it up to the "MAX" line with Maruti Genu-
ine Brake Fluid (MGBF) or DOT 3.
We highly recommend to use "Maruti Gen-
uine Brake Fluid" (MGBF).
7-15
Automatic Transaxle (AT)
Fluid
Specified Fluid
Use an automatic transaxle fluid SUZUKI
ATF OIL AW-1.
Fluid Level Check
NOTICE
Driving with too much or too little
fluid can damage the transaxle.
MIN MIN
You must check the fluid level with the
automatic transaxle fluid at normal operat-
ing temperature.
54MN132
To check the fluid level:
1) To warm up the automatic transaxle
fluid, drive the vehicle or idle the engine
until the temperature gauge indicates
normal operating temperature.
2) Then drive for ten more minutes.
NOTICE
Be sure to use the specified auto-
matic transaxle fluid. Using auto-
matic transaxle fluid other than
SUZUKI ATF OIL AW-1 may damage
the automatic transaxle of your vehi-
cle.
NOTE:
Do not check the fluid level if you have just
driven the vehicle for a long time at high
speed, or if you have driven in city traffic in
hot weather. Wait until the fluid cools down
(about 30 minutes), or the fluid level indi-
cation will not be correct.
3) Park your vehicle on level ground.
4) Apply the parking brake and then start
the engine in "P" (Park). Let it idle for
two minutes and keep it running during
the fluid level check.
5) With your foot on the brake pedal,
move the gearshift lever through each
gear, pausing for about three seconds
in each range. Then move it back to the
"P" (Park) position.
WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or
the vehicle can move suddenly.
EXAMPLE
79MH0-74E
75F086