Operating JVC's Audio/Video Components
You can use the remote control to operate other JVC's
components.
Operating Audio Components
A/V CONTROL RECEIVER
CATV/DBS
VCR
DVD
DVD MULTI
TV/DBS
VCR
BASS
−
+
SURROUND
SURROUND
ON/OFF
MODE
BASS BOOST EFFECT
1
SOUND
TEST
4
DIMMER
7/P
MUTING
10
RETURN
CA TV/DBS
CONTROL
CONTROL
+
CH
TV/VIDEO
−
+
/REW
TUNING
−
REC
PAUSE
RM-SRX7020J REMOTE CONTROL
When you press one of the following buttons, the remote
control operation mode appears on the display window.
A/V CONTROL RECEIVER
Ex.: When you press CD.
Buttons on the Remote Control
FM/AM
CD
PHONO
TAPE/CDR
DVD
DVD MULTI
TV/DBS
VCR
CATV/DBS CONTROL
CONTROL
SOUND
34
TV
AUDIO
CD
FM/AM
TAPE/CDR
PHONO
TREBLE
−
+
ANALOG/DIGITAL
SLEEP
INPUT
– CENTER +
2
3
MENU
– REAR • L +
5
6
ENTER
– REAR • R +
8
9
– SUB WOOFER +
0
+10
100 +
FM MODE
+
+
TV VOL
VOLUME
−
−
FF/
CONTROL
Remote Control Operation Mode
TUNER
CD
PHONO
TAPE
DVD
DVD
TV
VCR
DBS
VCR or TAPE or CDDSC
SOUND
IMPORTANT:
To operate JVC's audio components using this remote control:
• You need to connect JVC's audio components through the COMPU
LINK-4 (SYNCHRO) jacks (see page 31) in addition to the
connections using cables with RCA pin plugs (see page 7).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 11.)
• Refer also to the manuals supplied with your audio components.
Sound Adjustment
You can always use the following buttons:
SURROUND ON/OFF : Turn on or off the Surround modes.
SURROUND MODE
: Select the Surround modes.
After pressing SOUND, you can use the following buttons for sound
adjustment:
SUBWOOFER +/–
: Adjust the subwoofer output level.
CENTER +/–
: Adjust the center speaker output level.
REAR•L +/–
: Adjust the left rear speaker output level.
REAR•R +/–
: Adjust the right rear speaker output level.
EFFECT
: Select the DAP effect level.
TEST
: Turn on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CONTROL to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
Tuner
You can always use the following buttons:
FM/AM
: Alternate between FM and AM.
After pressing FM/AM, you can use the following buttons for tuner
operations:
1 – 10, +10
: Select a preset channel number directly.
• For channel number 5, press 5.
• For channel number 15, press +10, then 5.
• For channel number 20, press +10, then 10.
TUNING +/–
: Tune into stations.
FM MODE
: Change the FM reception mode.