D-Link DWL-120 Quick Installation Manual page 7

H. Network Type:
The factory setting is
set to Infrastructure.
Ad-Hoc mode is
used for peer-to-peer
networking.
H
I
J
K. Default Settings:
Reverts the DWL-120
back to its factory
default settings.
I. SSID: The Service Set Identifier is
the name assigned to the wireless
network. The factory SSID setting
is set to default. Make changes
here to match the SSID on existing
Wireless Router or Access Point.
L
K
M
L. WEP Settings: Will
allow you to configure
the Encryption for your
DWL-120. By default
WEP is disabled.
J. TxRate: You can
adjust the transmis-
sion rate to get the
best signal possible
depending on your
usage and your
environment.
M. Advanced Settings:
configure advanced settings for
Power, RTS and Fragmentation
Threshold.
To