Interface In The User Program (Status Of Blocks) - Siemens CP 342-5 Manual

Notes on operation

4.3 Interface in the user program (status of blocks)

4.3 Interface in the user program (status of blocks)
Status displays with the program block AG_SEND
For the CP 342-5 (6GK7 342-5DA03-0XE0), note the following over and above the
information in /4/ (Page 48), Release 03/2010:
DONE ERROR
0 1
Status displays with the program block DP_DIAG
For the CP 342-5 (6GK7 342-5DA03-0XE0), note the following over and above the
information in /4/ (Page 48), Release 03/2010:
DONE ERROR STATUS
1 0 0000
1 0 8248
38
STATUS Meaning
8315 Possible additional meaning:
H
This error code can also occur with bus problems (for example physical disturb-
ances due to bad cable connections or different settings for the transmission speed
on the nodes).
Possible Meaning
with DTYPE
0, 1 Job completed without error
H
and 4-9
Note:
With DTYPE 2, 3 and 10, error-free execution is indicated by a status
code other than "0". Below (see table DP_DIAG codes in /4/ (Page 48)),
you will see the detailed status codes for error-free execution for the
range:
82XX
If an error occurs in execution, you receive status codes in the following
ranges:
80XX
2, 3, 10 Job completed without error
H
Note: This is the default code for the named diagnostics types if there is
no special situation to signal.
H
, 83XX , 8FXX
H H H
CP 342-5 / CP 342-5 FO
Manual, 07/2017, C79000-G8976-C146-10