Specifications; Tires And Wheels - Toro 22604 Operator's Manual

Specifications

Engine ......................................... 25 HP (18.6 kW) Kohler
Hopper Opening......................... 6 inch (15 cm) maximum
Wheels & Tires ............................... High-Speed, 4.80 x 12
Hitch Coupler ................................................ 2 inch (5 cm)
Safety Chains ........................................................ Standard
Jack Stand with two caster wheels ................. 4.10/3.50 x 4
Fuel Tank Capacity .................................. 5.5 Gal. (20.8 L)
Length ................................................ 101 inches (256 cm)
Width ................................................. 35.5 inches (90 cm)
Height .............................................. 79.4 inches (202 cm)
Weight ................................................... 1056 lbs (478 Kg)
Towing
WARNING
Do not tow over 45 mph (75 km/h).
IMPORTANT Always turn fuel valve to the OFF position
before transporting the machine.
1. Raise hopper and lock into the up position. Rotate the chute
toward the rear of the machine, lock in position with the
chute locking pin and tighten chute locking knob.
2. Crank the handle of the lift jack to align the coupler with
the ball of the tow vehicle.
3. Remove the locking pin from the lever, squeeze the latch
lock and lift the lever up to open the coupler (Figure 5).
Figure 5
1. Tongue 4. Coupler
2. Lever in locked position 5. Safety chains
3. Locking pin
4. Attach coupler to a class I or higher 2 inch
(50.8 mm) ball on a towing vehicle and latch securely.
• If coupler does not fit over the ball, turn adjustment nut one
turn counter-clockwise.
• If coupler hitch is too loose on the ball, turn adjustment nut
one turn clockwise.
WARNING
Failure to properly engage the hitch ball in the coupler
ball socket and securely lock the coupler latch mechanism
can cause the unit to become detached from the tow
vehicle while traveling, which may cause serious injury
and property damage.
5. Install the locking pin to secure the lever (Figure 5).
6. Cross or "X" the safety chains and attach them to the holes
on the hitch.
7. Plug tail light wire harness connector to the tow vehicle
connector. Check to make sure the brake lights illuminate
properly with the brake pedal applied and the taillights
flash when the turning signals are use.
1. Release pin
8. Raise jack stand (Figure 6) so caster wheels are free of the
ground, pull the release pin and rotate wheels rearward and
lock in the horizontal position.

Tires and Wheels

The most common cause of tire trouble is under-inflation. It is
important that you maintain full air pressure as indicated by
the tire manufacturer on the tire's sidewall or on the trailer
manufacturer's certification label.
Inflate main axle tires to ....................... 60 psi (410 kpa)
Check the torque of the wheel lug nuts initially and after the
first 10 hours of operation.
Torque wheel lug nuts to .... 80-90 ft. lbs (108-122 N·m)
7
Figure 6
2. Jack stand